Harry
-
Posts
46 -
Joined
-
Last visited
Posts posted by Harry
-
-
Hi Toni
You need a free-swing fire door closer. For example the Fireco Freedor fire door closer and retainer allows the door being used like any normal door but will trigger an integral door closer when a fire breaks out.
Harry
-
Hi, smoke alarms should be replaced every ten years, as beyond that the sensors start to deteriorate. So you were lucky so far.
Harry -
Hi Sean, these extinguishers have been tested with 35,000 Volt and have to be safe up to this level of voltage. The difference from 35,000 to 1,000 Volt is safety margin to cover the manufacturers against any claims.
Harry
-
Hopefully it is just the screed. It is known to trigger CO alarms.
Harry
-
Hi
A technical solution would be to install what is called a 'Free-swing door closer' . These allow a fire door to open and close without any resistance from a normal door closer, however, should there be a fire, the door closer function is activated and the door closes, protecting you from fire in corridors etc.
Harry
-
Hi Tim
Our fire door frames are 32mm thick, which is about half an inch thicker than a normal non-fire door frame, so you can expect to lose about one inch in the width of the door leaf.
I can only speak about our fire doors, but our glazed fire doors would not work with your proposed sliding mechanism as the wooden edging around the glass protrudes (see image) and would catch.
Harry
-
Hi Pammie, the most likely culprit is a CO alarm with a low battery sitting on a shelve or in a drawer. Neither the cabling nor the base of an EI141 will be able to beep.
Harry
-
Hi, it is definitely not the plate that beeps, as the plate has no sounder. It will be a CO alarm with low battery hidden away in the room somewhere.
Harry
-
Hi Tim, yes, bespoke fire doors with glazing and matching fire door frames can easily be ordered. You need to measure the structural opening (take off architrave first) and then use the configurator to select the finer details of the fire door, such as wood veneer, glazing ect.
Harry
-
-
Hi, please have a look if you can identify the replacement date. The alarm might be too old by now and might need to be replaced. Could you post a photo of the alarm? I might then be able to help further.
Harry
-
Hi, the battery is not working any longer. If the alarm is less than ten years old you can contact the manufacturer for a free replacement, as the alarms have a ten year warranty. If it is older you need to replace the smoke alarm unfortunately yourself. As the ST-620 production was stopped a few years ago you need to upgrade to the ST620 replacement alarm, which fits the same base.
Harry
-
Hi Tania,
Your case shows how important it is to have CO alarms. With you having high CO levels in your blood and the alarm having gone off, there has most likely been a CO exposure. Sometimes boilers only have short term CO leaks. Short term CO peaks can result from wind and certain weather conditions pushing the fumes of the boiler back down the flue. When a boiler starts up and the flue is cold this can also create short term CO leaks.
Has the chimney or flue been been swept this autumn? There could be a physical partial blockage in the flue.
Harry
-
Hi Martin, this is very difficult to answer, as there are many different AFFF chemicals in use. Most of them are harmful, often carcinogenic and yes, if you were encased entirely by foam, you would suffocate. There is, of course, a balance to be made between saving lives from fire and not harming people with chemicals. For fires inside of closed spaces there is sometimes a possibility to use de-ionised water mist extinguishers instead of foam. De-ionised water mist extinguishers can be sprayed directly onto people without harming them (just remember that drinking de-ionised water in significant quantity is harmful).
Harry
-
Hi Syd
Most likely it did its job and detected CO. Sometimes there are spikes in CO (start up of boiler, gust of winds pushing air down a chimney etc)
Harry
-
Hi, that sounds a rather risky advice, how would you ensure that that person is there ALL the time? Why not simply use a fire door retainer that holds a fire door open when required but allows the fire door closer to close the door when there is a fire. These are in very widespread use.
Harry
-
Hi George, here some fire rated air vents that we sell. The intumescent material inside swells in a fire and closes off the vent.
Harry
-
Hi Katy
If the alarm has been activated in the last 24 hours, the internal memory is set and the alarm will flash red twice every 40 seconds. After 24 hours this should revert to once every 40 seconds.
Harry
-
Hi Mohan, you just need to remove the alarm from the base and take the battery out. Press the test button to drain the residual power. Here is a video to show you how to remove the Ei141from the ceiling. If you can still hear beeps they will be from a carbon monoxide alarm with a low battery nearby.
Harry
-
Hi, this smoke alarm is the replacement for i240c and all you have to replace is the alarm including base. The wiring can stay in place as long as it fulfills general safety requirements.
Kind Regards
Harry
BRK 660MBX beeping
in Smoke Alarms
Posted
Dear Sir/Madam
Two possibilities:
1) your power supply does not reach the alarm unit (wrong or interrupted wiring). You can exclude this possibility by switching heads with one of the other units. If the replacement unit also beeps there is a power supply issue.
2) if there is a technical fault the alarm needs replacing. Please contact your seller for an exchange under warranty.
Harry