Jump to content

green-foam

Power Member
  • Content Count

    364
  • Joined

  • Last visited

1 Follower

Contact Methods

  • AIM
    see below
  • MSN
    see above

Profile Information

  • Gender
    Not Telling

Recent Profile Visitors

16,474 profile views
  1. It is worth checking that you do not have another alarm (Smoke or carbon monoxide) nearby or in a drawer / top of a cupboard as beeping every 90 seconds does indicate low battery, but you have to change the battery in the correct device. Often there have been posts similar to yours and they post back saying they "found an old device hiding with a low battery" If it helps I have been called to more than one case where the smoke alarm is beeping, only to find it is the smoke alarm beeping, but not the suspected one, but one further along the hall that is beeping. (Not found one in a drawer,
  2. For future reference: CO2 is carbon dioxide and is found in CO2 fire extinguishers, also it is what makes drinks fizzy. CO is carbon monoxide and is often found in improperly burnt materials. (Wood, gas, oil, coal) Both are colourless gasses, carbon dioxide is heavier than air, and carbon monoxide is roughly the same density as air. Carbon monoxide detectors can be activated by other gases, even newly laid screed has been known to activate a CO detector. There is such a thing as a CO2 detector, they also detect other gasses and are used in some industries (They are als
  3. If the smoke alarm has been proven to have a problem, then there is only one thing you can do, change it, as there are no user serviceable parts inside.
  4. Is it a fire alarm or smoke alarm? (They are NOT the same)
  5. As AnthonyB has said, you have connected it to the switched live not the permanent live.
  6. It is at the end of its life, I would suggest you get a replacement ASAP Safelincs can supply you with a new CO alarm for around £17 Click here
  7. Since the cable was cut and has been repaired I would suggest you start there. You could also check the connections for each alarm are the same.
  8. Like you should have been, I was asleep at 02:00 so could not advise, I am assuming you have stopped it by now, all you can do to stop any smoke detector from chirping is change its battery. I don't expect you to have spare batteries in your house, although to be honest it is a good idea (and I do have new batteries around the house) you can take the detector down and take its battery out, then put the detector on the kitchen table, the idea being that you then change the battery and put the detector back, often I have visited houses and I see a backplate on the ceiling and no smoke detec
  9. I would assume you have a single LED emergency light, normally they are green, but in a power failure they change to white. (See example images) If it is showing white that means the unit has no mains, or it has failed, I would check that it has mains first. Below are two images of the same light. Yes it is one LED it has been developed for sole use as an emergency light. When the unit has mains it lights up as a not bright green, in a mains failure it changes to a bright cool white and like other emergency lights, it will last for 3 hours. They are small and unobtrusive and can di
  10. I am not there, can you be more specific please. What battery did you change, what "keeps going off" why did you decide to change the battery?
  11. Did you mean to ask, "can you sue them for selling them to you"? For that answer you would need to seek legal advice, which this forum can not give.
  12. If you could buy a fire safety label then "everyone" would do it just to say the item is safe, when indeed this may not be the case. You can however legally give it away providing you point out it has no fire safety label, or take it to the tip like everyone else does. It's a sad thing to do, but its down to liability at the end of the day.
  13. Both would have sounded as they are interlinked. Believe it or not, it's not uncommon for smoke alarms to false alarm (Although in theory they shouldn't, it does happen) Sadly there is not possible to say "do xyz and you will be fine" as it depends on why one went off. (Being interlinked, one will cause the other to activate) But you should check the age of the detectors, they should be changed when they are 10 years old, also if they have standby batteries, how old are they? You should also clean them once a year (Vacuum cleaner and the crevice tool if you have)
  14. I would suggest you "start again" and change the battery in one detector then switch the mains on, and repeat for each detector, it sounds like you have a battery / detector incompatibility problem. This is the easiest non technical way to find out, although somewhat tedious, and also check the age of all smoke detectors, the life span is 10 years.
×
×
  • Create New...